GOVERNMENT
OF INDIA
DIRECTORATE GENERAL OF SUPPLIES AND DISPOSALS
JEEVAN TARA BUILDING , 5,PARLIAMENT STREET,
NEW DELHI::110001
TELEX NO.3345586/3340497
RATE CONTRACT NO.EF&DEFEB/ES-1/RC-A10E0000/1005/31/COAD/2855
DATED
:: 10-12-2004
TO
M/S Myna
Electronics Ltd.,
A-83,
G.T. Karnal Road Industrial Area,
Azad
Pur, Delhi-110033.
Phone no. 27211521,27115111, Fax no. 27225164 (M) 9810002689
E-mail
: myna-delhi@vsnl.net
Code no. M-1535
SUBJECT:: RATE CONTRACT FOR THE SUPPLY OF EF&DEF With Electronic Ballast VALID FROM
07/12/2004 to 31/12/ 2005.
REFERENCE:: THIS OFFICE TENDER ENQUIRY EF&DEFEB/ES-1/RC-A10E0000/1005/31
(II)YOURQUOTAIONNO.MEL/TE/EF&DEFEB2004-05/2470
Dated 12-08-2004
Dear Sirs,
You
are hereby informed that your above referred tender read with subsequent letter
mentioned above for the stores specified in the schedules annexed has been
accepted. This rate contract will be
governed by the terms and conditions brought in the Form No.DGS&D-1001
which is available from DGS&D sales counters on payment of Rs.50/-.
The Rate Contract and the Schedules annexed hereto shall be the sole
repository of this rate contract/transaction.
SCHEDULE
ANNEXED::
YOURS
FAITHFULLY,
(JAGDIP RANA)
(SECTION
OFFICER)
FOR AND ON BEHALF OF THE PURCHASERS NAMED
IN THE FORM DGS&D-1001.
Contd…2/-
-2-
COPY TO::
1.
The Chief
Controller of Accounts,(Supply Wing) Department of Commerce, New Delhi. (Through Auth. Cell) This issues with the
approval of DOC/Finance.
2.
The Dy.
Director General of Supplies & Disposals, Kolkata.
3.
The
Dy.Director General of Supplies & Disposals, Mumbai.
4.
The Dy.
Director General of Supplies & Disposals, Chennai.
5.
The Dy.
Director General of (Q.A.),Kolkata.
6.
The Dy.
Director General of (Q.A.),Mumbai.
7.
The Dy.
Director General of (Q.A.) Chennai.
8.
The Dy.
Director General of (Q.A.),DGS&D, NEW DELHI.
9.
The
Inspecting Authority –ADG(QA)
DGS&D. NEW DELHI.
10.
THE DIRECTOR
(Q.A.) OFFICER CONCERNED DIRECTOR(QA) NI CIRCLE. NEW DELHI.
11.
C.A.
12.
M.I.S. CELL
13.
O.L.SECTION
14.
L.C.
15.
ALL DDOs list
maintained by DGS&D. 16. R.L.O.
(JAGDIP RANA)
(SECTION OFFICER)
FOR DIRECTOR GENERAL OF SUPPLIES AND
DISPOSALS.
Contd…3/-
-3-
1.RATE CONTRACT NO.:: EF&DEFEB/ES-1/RC-10E0000/1005/31/COAD/2855
for the supply of EF&DEF With EB
Dated 10-12-2004.
2.ADVANCE R/C. NO.:: EF&DEFEB/ES-1/RC-10E0000/1005/31/COAD/2855
for the supply of EF&DEF With EB
Dated 07-12-2004.
3(A) NAME AND FULL ADDRESS:: M/S Myna Electronics Ltd.,
OF THE FIRM A-83, G.T. Karnal Road Industrial Area,
Azad Pur, Delhi-110033.
(B) NAME AND FULL ADDRESS:: (1) M/S Myna Electronics Ltd.,
OF MANUFACTURER A-83, G.T. Karnal Road Industrial Area
Azad Pur, Delhi-110033 (2) M/S Myna Electronics Ltd.,
143-144, Sector-5, IMT,
Manesar, Gurgaon (Haryana)
(C ) BRAND :: ‘MYNA’ (OWN MAKE ONLY)
4. VALIDITY OF RATE CONTRACT:: 07/12/2004 TO 31/ 12/2005.
Item No. Description of Item Specification Unit Rate per unit
Drawing No.
1 2 3 4 5
SCHEDULE – IV: ELECTRONIC BALLAST
Specification: Electronic ballast confirming to IS- 13022
(Part 1: 1991 with amendment No. 1 and IS: 13022: Part 2: 1991 with amendment
No. 1 & 2). The electronic ballast
shall be suitable for tubular fluorescent lamps confirming to IS: 2418 Part 1:
1997 with amendment 1 to 3 IS: 2418: part 2: 1977 with amendment No. 1and IS:
2418 Part 4 / 1977. The ballast shall
be suitable for assembly on fittings and shall be complete with suitable length
of wire for making connection.
20 Electronic Ballast. 40 Watt 260.00
TENDERERS TO NOTE: The ballast shall
satisfy at rated voltage all performance requirements shall work satisfactorily
in the input voltage range of 150 Volt to 270 Volt and shall comply with
additional requirement as noted below.
TYPE TEST: The ballast when used along with
the lamp shall satisfy the following requirements of type test:
a.
The total
power consumption by the electronic ballast along with the lamps of rating 20W
and 40W shall not exceed 20W and 40W respectively and measured by true RMS
power meter and the power factor shall not be less than 0.90.
b.
The lumen
output of standard fluorescent tubular lamps of 36W and 40W rating when
operated with the electronic ballast at rated input voltage should not be less than
90% of the value obtained when operated with electro- magnetic ballast.
c.
Electro
magnetic interference caused by the electronic ballast should not exceed the
limit prescribed in BN: 55015/IS: 6842-1997 for radiated interferences.
d.
Electronic
ballast shall comply with the main terminal interference voltage limit given in
table 21 A of IS: 6842-1997 (see para 10.5.4.4 and 10.5..5 of ISS).
e.
The open
circuit voltage should be cut off within 30 seconds to ensure safety.
f.
Endurance
test with to shall be 55 degree C.
g.
The ballast
shall meet the limit for current distortion as per table 1 of IS: 13021: part
2: 1991 with amendment No. 1 & 2.
h. All other tests as per IS: 13021: Part 1: 1991 with amendment No. 1 and IS: 13021: Part 2: 19191 with amendment No. 1& 2.
Contd…4/-
-4-
ACCETANCE TEST:
The ballast shall subject to the following
acceptance test during pre despatch
inspection test. Sampling plan for
acceptance test shall be as given in table 10 under column (N1+N2) of
IS: 1534: Part: 1977 with
amendment No. 1 to 4.
i Marking
as per IS: 13021 Part 1 : 1991 with amendment No. 1.
ii Moisture
resistance and insulation resistance test as per IS:13021: Part 1: 1991 with amendment No. 1
iii Protector
against electric shocks as per IS: 13021: part 1 : 1991 with amendment No. 1.
iv Electric
strength as per IS: 13021: part 1: 1991 with amendment No. 1.
v.
Circuit
starting conditions as per IS: 13021: Part 2: 1991 with amendment No. 1& 2.
vi.
Circuit power
factor as per IS: 13021: part 2: 1991 with amendment No. 1 & 2.
vii.
Operating
conditions as per IS: 13021: Part 2: 1991 with amendment No. 1& 2.
viii.
Supply
current as per IS: 13021 part 2 : 1991 with amendment No. 1& 2.
ix.
Operational
test for abnormal conditions as IS: 13021: Part 2: 1991 with amendment No. 1&
2.
x.
Test for
verification of current and total (including lamp) power consumed in comparison
to type tested ballast. The result
shall not vary by more than 2%.
xi.
Burn – in
test on 2% sample, subject to a minimum of 10 numbers at 270 volts 45 degree C
for 4 hours. The ballast shall continue
to perform satisfactorily after the rest.
6. TERMS OF DELIVERY:: F.O.R. Delhi/ New Delhi. / Manesar (Distt.Gurgaon)
Time of despatch. The present rate of
Excise Duty is @ 16% + 2% education cess on
Excise Duty i.e. 16.32%.
Charged extra as applicable on the date of supply.
The present rates of taxation are as under. Any
Statutory variation in taxation will be to buyers account.
FOR SUPPLIES FROM DELHI.
For supplies made from Delhi office LST shall be charged
@ 8%. CST shall be charged @4% against Form C/D
otherwise 10%.
FOR SUPPLIES FROM GURGAON/ MANESAR
The current rate of LST is 12% and CST is @4% against
Form C/D otherwise CST will be charged @ 12%.
9 Delivery Period:: Within 12 to 16 Weeks
10. MONETARY LIMIT :: Without limit.
11. SLAB DISCOUNT (IF ANY) Nil
Contd…5/-
-5-
12. PRICES:: PRICES ARE FIRM AND FINAL INCLUSIVE
OF PACKING,FORWARDING AND TRANSIT
INSURANCE CHARGES UPTO DESTINATION.
13 .MINIMUM QUANTITY IN :: NOT APPLICABLE
SINGLE SUPPLY ORDER.
14. STATUS OF RATE CONTRACT:: SSI
15
PAYING AUTHORITY : The Chief Controller of Accounts,
(Supply Wing), Deptt. of Commerce,
New Delhi.
INSTRUCTION TO THE FIRM::
ii) That before entertaining any supply order placed by a DDO against the subject R/C. DDO has to furnish the following certificate to the firm :-
a) They are Central Govt Department drawing funds from Consolidated Fund of India.
b) The expenditure involved for the purchase has received the sanction of the competent authority
. c) The funds are available under the proper head in the sanctioned budget allotment for the year……..
They have been fully authorised by the department concerned to sign the supply order and incur the liability in respect of the stores being ordered.
You are, therefore, informed that the certificate as per above requirement may be obtained from the DDO before entertaining any supply order.
16.INSPECTION AUTHORITY : ADG(QA), Directorate General of
Supplies & Disposals, 5, Sansad Marg,
New Delhi::110001.
17. QUALITY ASSURANCE OFFICER : Director(QA), New Delhi or his
authorised representative.
18 . PLACE WHERE THE STORES :: M/S Myna Electronics Ltd.,, ARE TO BE TENDERED FOR A-83, G.T. Karnal Road Industrial Area,
Inspection. Azad Pur, Delhi-110033.
(2) M/S Myna Electronics Ltd.,
143-144, Sector-5, IMT,
Manesar, Gurgaon (Haryana)
Yours faithfully,
(JAGDIP RANA)
(SECTION
OFFICER)
FOR AND ON BEHALF OF THE PURCHASERS NAMED
IN THE FORM DGS&D-1001.